Rackmount-solutions E1000RM1U Manuel d'utilisateur télécharger pdf (Page 8)

English

The Load Level Bar Graph operates as follows:

LED #10: >10% load (green/red/yellow) LED will be green and illu-

minated when there is at least 10% of the rated capacity.

LED #30: >30% load (green/yellow) LED will be green and illumi-

nated when there is at least 30% of the rated capacity.

LED #50: >50% load (green/yellow) LED will be green and illumi-

nated when there is at least 50% of the rated capacity.

LED #70: >70% load (green/yellow) LED will be green and illumi-

nated when there is at least 70% of the rated capacity.

LED #90: >90% to approximately 109% load (red/yellow) LED will

be yellow and illuminated when there is approximately 90% of the

rated capacity to indicate that unit is near full capacity. The LED

will turn red at 110% load capacity to indicate an Overload condi-

tion.

The Battery Capacity Bar Graph operates as follows:

LED #90: >90% battery capacity (red/yellow) LED will be yellow

and illuminated until the battery’s capacity drops below 80% ca-

pacity and then it will extinguish.

LED #70: >70% battery capacity (green/yellow) LED will be yellow

and illuminated until the battery’s capacity drops below 60% ca-

pacity and then it will extinguish.

LED #50: >50% battery capacity (green/yellow) LED will be yellow

and illuminated until the battery’s capacity drops below 40% ca-

pacity and then it will extinguish.

LED #30: >30% battery capacity (green/red/yellow) LED will be yel-

low and illuminated until the battery’s capacity drops below 30%

capacity and then it will turn red. When the battery capacity drops

below 20% capacity the LED will extinguish.

LED #10: >30% battery capacity (green/red/yellow) LED will be yel-

low and illuminated until the unit issues a Low Battery Warning

Alarm and then it will turn red to indicate a Low Battery Warning.

The Multi-Function On/Off/Test Button functions as follows:

When the UPS is Off, press and release the On/Off/Test button

after one beep to turn the UPS On.

When the UPS is On, press and release the On/Off/Test Button

after one beep to turn the UPS Off.

When the UPS is On, press and hold the On/Off/Test button for four

beeps, then release the button. The UPS will perform a 5-second

Self Test.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Pas de commentaire

Rackmount-solutions E1000RM1U Manuel d'utilisateur Page 8