Rackmount-solutions XRT Series Manuel d'utilisateur télécharger pdf (Page 14)

INSTALLATION, STEP BY STEP

1. Insure UPS Power switch is OFF. Place the optional XRTBP

battery pack(s), if used, and XRT UPS in its final location.

2. When installing the XRT1000 and above UPS’s or the XRT600

with optional battery pack(s):

a) Remove the self stick protective strip from the rear of the XRT600

(not required on XRT1000 , 1500, and 2000), and from the optional

battery pack cable.

b) Loosen the retainer screws on the rear of the UPS and drop the

retainer bracket down.

c) Plug the battery pack cable connector into the XRT remote battery

pack connector insuring connections mate RED to RED and

BLACK to BLACK. Push the retaining bracket “up” to secure the

battery connector in place and re-tighten the screws.

d) Verify the bracket will not allow removal of the connector. Each

battery pack is “daisy chained” in a similar fashion with the cable

from the last battery pack connected to the previous pack. Remove

the protective strips only from the battery connectors that are

used.

NOTE: When the protective strip is removed from the XRT UPS or the

XRTBP cable connector, battery system voltage (48 VDC) is

present at these connector contacts. Please keep the connector

contacts covered with the protective strip when not mated with

another connector.

Battery Pack Connection Diagram

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 42 43

Pas de commentaire

Rackmount-solutions XRT Series Manuel d'utilisateur Page 14