Rackmount-solutions XRT Series Manuel d'utilisateur télécharger pdf (Page 21)

Status Menu

The status menu allows you to read the parameters of the UPS according

to the flowchart shown below. The button under the word “Scroll” will step

you to the next selection and the button under the word “Menu” will step

you to the TEST menu.

NOTE: If a power event is happening, the screen describing the

event will appear.

Load xxx% : Percentage of load compared to power

rating of the unit. If the load shows greater than 100

percent, then the load is too high for the UPS.

Load xxxVA : VA load currently being supplied by

the UPS. If the load exceeds the VA rating of the unit

then the load is too high for the UPS.

AC Input xxx.xV : Indicates the incoming AC Volts. If

the voltage is out of range for your UPS then you have

the wrong model type or your commercial power is

Input xx HZ : Indicates incoming frequency. If the

frequency is out of the acceptable range, then you

have bad incoming power.

Output xx HZ : Indicates output frequency.

AC Output xxx.xV : Indicates output voltage.

Battery xx.xV : Battery voltage. The acceptable

values are in the range of 39 to 56 volts.

Temp xx.xC : Indicates internal temperature of unit.

Load 50%

Scroll

Load 750VA

Scroll

AC Input 120.0V

Scroll

Input 60Hz

Scroll

Output120.0V

Output 60Hz

Scroll

Battery 50.2V

Scroll

Temp 30.1C

Scroll

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 42 43

Pas de commentaire

Rackmount-solutions XRT Series Manuel d'utilisateur Page 21